Problem with prints squished in the corner


Some people have been encountering problems with their prints coming out squished into the corner of the bed, rather than starting at the centre of the bed.


The printer coordinate system for a cartesian printer (e.g. not a polar delta printer) starts with x,y = 0,0 at the corner of the bed. You need to tell your slicer that this is the case, so that the correct GCode files are produced.


For example, in Cura, you need to go into the machine settings, and uncheck the box for β€œMachine centre 0,0”. See below:

printing-coordinates.txt Β· Last modified: 2020/12/25 02:13 by