a5s:mesh-bed-levelling
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
a5s:mesh-bed-levelling [2019/03/23 01:35] โ created samuelpinches | a5s:mesh-bed-levelling [2020/12/25 02:13] (current) โ external edit 127.0.0.1 | ||
---|---|---|---|
Line 5: | Line 5: | ||
- Select Level Bed then choose Level Bed (not Cancel) in the sub-menu. | - Select Level Bed then choose Level Bed (not Cancel) in the sub-menu. | ||
- Wait for Homing XYZ to complete. | - Wait for Homing XYZ to complete. | ||
- | - When Click to Begin appears, press the controller | + | - When Click to Begin appears, press the " |
- | - Use the controller wheel to adjust Z so that a piece of paper can just pass under the nozzle.ย | + | - Use the up/down buttons |
- | - Press the controller | + | - Press the " |
- Repeat steps 4-5 until completed. | - Repeat steps 4-5 until completed. | ||
- | - | + | - Use Control > Store memory to save the mesh to EEPROM, if desired. |
- Dont forget to add "M420 S1" in your start gcode, so that your printer uses the level mesh when printing! | - Dont forget to add "M420 S1" in your start gcode, so that your printer uses the level mesh when printing! | ||
a5s/mesh-bed-levelling.txt ยท Last modified: 2020/12/25 02:13 by 127.0.0.1