Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
| a5:getting-started [2019/02/09 03:22] – samuelpinches | a5:getting-started [2019/02/09 03:24] – [2. Software Setup & Manual] samuelpinches |
|---|
| |
| === Printing Settings & Profiles === | === Printing Settings & Profiles === |
| | * **NEW: download the [[https://ultimaker.com/en/products/ultimaker-cura-software|Cura]] 4.0.0 beta and the JGAurora A5 has a profile now included!** |
| * **[[a5:printing-profiles |Slicer Software Setup:]]** See [[a5:printing-profiles | this page]] for advice on setting up your printing software (slicer) | * **[[a5:printing-profiles |Slicer Software Setup:]]** See [[a5:printing-profiles | this page]] for advice on setting up your printing software (slicer) |
| * **[[a5:printing-profiles |Material Printing Settings:]]** See [[a5:printing-profiles | the same page]] for suggested printing settings, and some contributed pre-configured profiles for various slicers and materials. | * **[[a5:printing-profiles |Material Printing Settings:]]** See [[a5:printing-profiles | the same page]] for suggested printing settings, and some contributed pre-configured profiles for various slicers and materials. |
