a5:disassembly
Differences
This shows you the differences between two versions of the page.
| Next revisionBoth sides next revision | |||
| a5:disassembly [2018/02/12 16:35] – created pinchies | a5:disassembly [2018/02/12 16:41] – pinchies | ||
|---|---|---|---|
| Line 10: | Line 10: | ||
| - The top and bottom halves will still be attached by the y-axis cable chain. | - The top and bottom halves will still be attached by the y-axis cable chain. | ||
| - You will have to cut cable ties to disassemble the printer further than this point. You may prefer to stop at this point, and find something to prop open the case at an angle while you work on it. | - You will have to cut cable ties to disassemble the printer further than this point. You may prefer to stop at this point, and find something to prop open the case at an angle while you work on it. | ||
| + | |||
| + | |||
| + | |||
| + | ===== Re-assembly Tips ===== | ||
| + | * Check the y-axis cable chain is properly connected | ||
| + | * Dont forget to reconnect y-axis motor and endstop cables. | ||
| + | * Dont forget to reconnect the LCD module data cable (8 pin connector), the LCD module USB cable, and the LCD module filament sensor (two pin connector). | ||
| + | |||
| + | {{: | ||
a5/disassembly.txt · Last modified: 2020/12/25 02:13 by 127.0.0.1
