start-and-end-gcode
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
start-and-end-gcode [2019/11/16 12:59] โ [Ending GCode] samuelpinches | start-and-end-gcode [2019/11/16 13:00] โ [Ending GCode] samuelpinches | ||
---|---|---|---|
Line 69: | Line 69: | ||
* M140 S[first_layer_bed_temperature] | * M140 S[first_layer_bed_temperature] | ||
* M109 S[first_layer_temperature_0] | * M109 S[first_layer_temperature_0] | ||
- | //ย | + | ย |
- | For Cura [[https:// | + | For Cura you can add additional wait commands to the start gcode if you want, but note that the format is slightly different |
* M190 S{print_bed_temperature} ; Set bed temp. | * M190 S{print_bed_temperature} ; Set bed temp. | ||
* M140 S{print_bed_temperature} ; Wait for bed temp. | * M140 S{print_bed_temperature} ; Wait for bed temp. | ||
- | * M109 S{print_temperature} ; Wait for all used extruders to reach temperature.// | + | * M109 S{print_temperature} ; Wait for all used extruders to reach temperature.ย |
// Thanks to Poikilos for info on Wait for temperature.// | // Thanks to Poikilos for info on Wait for temperature.// | ||
---- | ---- |
start-and-end-gcode.txt ยท Last modified: 2020/12/25 02:13 by 127.0.0.1