Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision |
| pronterface [2018/04/28 19:47] – samuelpinches | pronterface [2018/04/28 19:47] – samuelpinches |
|---|
| |
| ---- | ---- |
| | |
| | Common Errors & Faults |
| |
| If you see an error about "MIN_TEMP" the printer has detected a temperature that is too low, and it thinks that a sensor is either damaged or missing. For safety, the printer will then refuse to heat up, to prevent burning your house down! There is a broken wire, or loose connection somewhere. Perhaps a leg of the thermistor has broken off, or a cable is detached or loose? | If you see an error about "MIN_TEMP" the printer has detected a temperature that is too low, and it thinks that a sensor is either damaged or missing. For safety, the printer will then refuse to heat up, to prevent burning your house down! There is a broken wire, or loose connection somewhere. Perhaps a leg of the thermistor has broken off, or a cable is detached or loose? |
