not-heating
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
not-heating [2018/04/21 23:02] โ samuelpinches | not-heating [2018/07/12 14:41] โ samuelpinches | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== Heating Problems ===== | + | ====== Heating Problems |
**You notice that perhaps your bed, or nozzle is not heating up. This page will help you troubleshoot this problem.** | **You notice that perhaps your bed, or nozzle is not heating up. This page will help you troubleshoot this problem.** | ||
Line 19: | Line 19: | ||
If you see an error about " | If you see an error about " | ||
- | ==== 3. Check your sensor | + | ==== 3. Check your sensors and heaters |
- | If you know how to use a multimeter (or you have a kind friend who does), you can measure the resistance of the thermistors (temperature sensor), and they should measure approximately 100K ohms at 25C. From there, you can trace the cables, plugs, and wires until you find the broken connection. You can check the resistance of the heated bed or nozzle heater cartridge as well, the bed should measure around 2 to 3 ohms, and the nozzle should measure around 15 to 20 ohms. | + | If you know how to use a multimeter (or you have a kind friend who does), you can measure the resistance of the thermistors (temperature sensor), and they should measure approximately 100K ohms at 25C. From there, you can trace the cables, plugs, and wires until you find the broken connection. You can check the resistance of the heated bed or nozzle heater cartridge as well, the bed should measure around 2 to 3 ohms, and the nozzle should measure around 15 to 20 ohms. Check the resistance at the sensor/ |
+ | ย | ||
+ | A video tutorial on replacing the Hot-End Thermistor can be found [[https:// | ||
+ | ย | ||
+ | ==== Further Troubleshooting ====ย | ||
+ | **If you are still getting faulty temperature readings after checking your thermistors are ok, it may be that your motherboard thermistor sensor port is damaged. There is information on using the spare port [[a5: | ||
{{page> | {{page> |
not-heating.txt ยท Last modified: 2020/12/25 02:13 by 127.0.0.1