jgmaker-magic
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
jgmaker-magic [2019/07/24 17:11] โ samuelpinches | jgmaker-magic [2020/08/19 11:34] โ samuelpinches | ||
---|---|---|---|
Line 24: | Line 24: | ||
------ | ------ | ||
+ | ==== Maintenance & Repair ==== | ||
+ | * [[https:// | ||
+ | |||
==== Upgrades ==== | ==== Upgrades ==== | ||
* Upgrade the bed print surface! You can order a 235mm x 235mm coated glass bed (e.g. ultrabase, superplate) which stick well, but make it much easier to remove prints after they are done! This printer bed has the same dimensions as Ender 3. Order from: [[https:// | * Upgrade the bed print surface! You can order a 235mm x 235mm coated glass bed (e.g. ultrabase, superplate) which stick well, but make it much easier to remove prints after they are done! This printer bed has the same dimensions as Ender 3. Order from: [[https:// | ||
Line 37: | Line 40: | ||
* [[http:// | * [[http:// | ||
+ | [[https:// | ||
+ | |||
+ | To install firmware on the JGMaker Magic, please follow the [[a5: | ||
==== Software: JGCreat or Cura ==== | ==== Software: JGCreat or Cura ==== | ||
jgmaker-magic.txt ยท Last modified: 2020/12/25 02:13 by 127.0.0.1