jgmaker-magic
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
jgmaker-magic [2019/04/15 23:39] โ samuelpinches | jgmaker-magic [2019/07/24 17:11] โ [Software: JGCreat or Cura] samuelpinches | ||
---|---|---|---|
Line 16: | Line 16: | ||
==== Where to Buy ==== | ==== Where to Buy ==== | ||
* [[https:// | * [[https:// | ||
+ | * [[https:// | ||
* [[http:// | * [[http:// | ||
+ | * [[https:// | ||
+ | * [[http:// | ||
+ | |||
+ | ------ | ||
==== Upgrades ==== | ==== Upgrades ==== | ||
- | * [[https:// | + | * Upgrade the bed print surface! You can order a 235mm x 235mm coated glass bed (e.g. ultrabase, superplate) which stick well, but make it much easier to remove prints after they are done! This printer bed has the same dimensions as Ender 3. Order from: [[https:// |
Line 27: | Line 33: | ||
* [[https:// | * [[https:// | ||
+ | ==== JGMaker Firmware ==== | ||
+ | JGAurora released the marlin fimware for the JGMaker Magic Here: | ||
+ | http:// | ||
==== Official Setup Video ==== | ==== Official Setup Video ==== | ||
{{youtube> | {{youtube> | ||
+ | |||
+ |
jgmaker-magic.txt ยท Last modified: 2020/12/25 02:13 by 127.0.0.1