a5:stepper-drivers
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
a5:stepper-drivers [2018/11/25 03:58] – samuelpinches | a5:stepper-drivers [2018/11/25 04:04] – samuelpinches | ||
---|---|---|---|
Line 27: | Line 27: | ||
| Example of Ground (GND) point: | | Example of Ground (GND) point: | ||
- | | Example of VRef measuring points: | + | | Example of VRef measuring points |
Line 40: | Line 40: | ||
- | ====Tuning TMC2XXX Stepper Drivers==== | + | ===== Tuning TMC2XXX Stepper Drivers ===== |
+ | |||
+ | If you have [[a5: | ||
The motor current must be sufficient to prevent stalling, but too high a current can cause the TMC2XXX to shut down due to overheating. **Cooling of the TMC2XXX stepper drivers with a fan is ESSENTIAL** for reliable operation. They may be quiet, but they are certainly run hot! | The motor current must be sufficient to prevent stalling, but too high a current can cause the TMC2XXX to shut down due to overheating. **Cooling of the TMC2XXX stepper drivers with a fan is ESSENTIAL** for reliable operation. They may be quiet, but they are certainly run hot! | ||
a5/stepper-drivers.txt · Last modified: 2020/12/25 02:13 by 127.0.0.1