a5:silent-stepper-driver-tmc2130
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| a5:silent-stepper-driver-tmc2130 [2018/11/04 20:39] – red_m | a5:silent-stepper-driver-tmc2130 [2020/12/25 02:13] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | **<WRAP center round alert 60%> | ||
| + | This guide will only work on the 1.1.9 Marlin firmware for the JG A5, which is in beta and may have extra bugs. | ||
| + | |||
| + | A 1.1.8 version may come out if someone else is willing to do one on the wiki however I don't use 1.1.8 | ||
| + | </ | ||
| + | ** | ||
| + | |||
| ==== Silent Stepper Driver TMC2130 | ==== Silent Stepper Driver TMC2130 | ||
| {{: | {{: | ||
| Line 188: | Line 195: | ||
| #endif | #endif | ||
| </ | </ | ||
| + | If you are intending to also use the Z axis and/or extruder, you will need to assign them pins and make sure you plug the CS wire from the driver into the corresponding pin. | ||
| **Make sure you install the TMC2130 Arduino library or you will get compiler errors about missing files.** | **Make sure you install the TMC2130 Arduino library or you will get compiler errors about missing files.** | ||
| Line 201: | Line 208: | ||
| - Insert mains plug. | - Insert mains plug. | ||
| - Power on the printer | - Power on the printer | ||
| - | - Use the Touch Display (Move) and check that the X and Y axes are moving in the right direction. | + | - Use the Touch Display (Move) |
| Make sure your X and Y (and Z if you also have the extra driver installed and wired) are going to correct way otherwise you'll need to make sure you did all the changes to the firmware. | Make sure your X and Y (and Z if you also have the extra driver installed and wired) are going to correct way otherwise you'll need to make sure you did all the changes to the firmware. | ||
a5/silent-stepper-driver-tmc2130.1541324342.txt.gz · Last modified: 2020/12/25 02:13 (external edit)
