a5:programmable-power-supply-control
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
a5:programmable-power-supply-control [2018/07/05 22:48] โ samuelpinches | a5:programmable-power-supply-control [2020/12/25 02:13] (current) โ external edit 127.0.0.1 | ||
---|---|---|---|
Line 4: | Line 4: | ||
The changes shown here require knowledge in the field of Arduino, Marlin firmware and electrical engineering and can overwhelm normal users. Also, I would like to point out possible dangers that exist in certain interventions. All adjustments have been checked for function. | The changes shown here require knowledge in the field of Arduino, Marlin firmware and electrical engineering and can overwhelm normal users. Also, I would like to point out possible dangers that exist in certain interventions. All adjustments have been checked for function. | ||
- | **Difficulty: | + | **Difficulty: |
**What is this about?** \\ | **What is this about?** \\ | ||
Line 183: | Line 183: | ||
AETEK Firmware:\\ | AETEK Firmware:\\ | ||
{{: | {{: | ||
- | \\ | + | {{: |
After the successful update of the MKS display firmware it should now look like this:\\ | After the successful update of the MKS display firmware it should now look like this:\\ | ||
Line 220: | Line 220: | ||
=== Operation via software (GCODES) === | === Operation via software (GCODES) === | ||
- | GCODES can be sent directly to the A5 via USB, e.g. Pronterface. \\ | + | GCODES can be sent directly to the A5 via USB, e.g. [[: |
There is also the option to send stored GCODES from a storage device, such as USB stick or SD card. \\ | There is also the option to send stored GCODES from a storage device, such as USB stick or SD card. \\ | ||
Which GCODES are of interest for this project?\\ | Which GCODES are of interest for this project?\\ |
a5/programmable-power-supply-control.1530794939.txt.gz ยท Last modified: 2020/12/25 02:13 (external edit)