a5:modifications:bltouch
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
a5:modifications:bltouch [2019/02/08 07:49] โ Beautify touliloup | a5:modifications:bltouch [2020/12/25 02:13] (current) โ external edit 127.0.0.1 | ||
---|---|---|---|
Line 60: | Line 60: | ||
< | < | ||
G28 ; home | G28 ; home | ||
- | G29 P1 ; start the automatic bed levellingย | + | G29 P1 ; start the automatic bed levelingย |
- | ; wait for bed levelling | + | ; wait for bed leveling |
G29 S1 ; save the mesh information into slot 1 | G29 S1 ; save the mesh information into slot 1 | ||
+ | G29 S0 ; save in slot 0 as well as Cura use slot 0 per default | ||
M500 ; save EEPROM | M500 ; save EEPROM | ||
- | M851 ; | + | M851 ; print the current setting |
M851 Z0 ; set offset to zero | M851 Z0 ; set offset to zero | ||
G28 ; home again | G28 ; home again | ||
Line 72: | Line 73: | ||
M851 Z-1.6 ; enter the measure distance, in this example, the head is 1.6mm above the printer bed | M851 Z-1.6 ; enter the measure distance, in this example, the head is 1.6mm above the printer bed | ||
M500 ; store the new configuration | M500 ; store the new configuration | ||
+ | G28 ; home again | ||
+ | G1 Z0 ; move the nozzle to height 0 - Then mesure again, if it's not right yet, restart at step M851 Z-1.6 (increase the value to bring the head closer to the bed) | ||
</ | </ | ||
+ | |||
+ | Keep adjusting | ||
If you need to change the height, simply do: | If you need to change the height, simply do: |
a5/modifications/bltouch.1549572594.txt.gz ยท Last modified: 2020/12/25 02:13 (external edit)