a5:mesh-bed-levelling-routine
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
a5:mesh-bed-levelling-routine [2018/08/25 14:04] โ samuelpinches | a5:mesh-bed-levelling-routine [2020/12/25 02:13] (current) โ external edit 127.0.0.1 | ||
---|---|---|---|
Line 57: | Line 57: | ||
If you want to check the mesh that you have produced, you can use the command "G29 S0" to print a mesh report to the command line history window. | If you want to check the mesh that you have produced, you can use the command "G29 S0" to print a mesh report to the command line history window. | ||
+ | |||
+ | |||
+ | ====Mesh Bed Levelling via LCD==== | ||
+ | If you have installed both the [[a5: | ||
+ | - Go the more menu. | ||
+ | - Press "mesh bed levelling" | ||
+ | - Use the "mesh up and down" buttons until the desired gap is correct. | ||
+ | - Press the "next point" button to go the next point. | ||
+ | - Repeat this until all the points have been levelled. | ||
+ | - After the last point is completed, when you press the "next point" button, the head will return to the home position. | ||
+ | - Press the "Save EEPROM" | ||
+ | - Don't forget to add M420 S1 to your [[: | ||
+ | |||
==== More Info ==== | ==== More Info ==== | ||
For more information on the mesh bed levelling process and options, please see the [[http:// | For more information on the mesh bed levelling process and options, please see the [[http:// |
a5/mesh-bed-levelling-routine.1535169861.txt.gz ยท Last modified: 2020/12/25 02:13 (external edit)