a5:mesh-bed-levelling-routine
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| a5:mesh-bed-levelling-routine [2018/04/23 22:29] – [After Performing Mesh Bed Levelling] samuelpinches | a5:mesh-bed-levelling-routine [2018/08/25 14:04] – samuelpinches | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== Mesh Bed Levelling ===== | ===== Mesh Bed Levelling ===== | ||
| Mesh bed levelling allows you to level the bed at as many points as you would like to, in a grid. This allows you to get perfect first layer height anywhere on the large bed - and it does not matter if it is warped or not! | Mesh bed levelling allows you to level the bed at as many points as you would like to, in a grid. This allows you to get perfect first layer height anywhere on the large bed - and it does not matter if it is warped or not! | ||
| - | |||
| - | |||
| DaHai has an [[https:// | DaHai has an [[https:// | ||
| Line 16: | Line 14: | ||
| Next, perform the following steps: | Next, perform the following steps: | ||
| - | - Download and install [[https:// | + | - Download and install [[https:// |
| - Open pronterface, | - Open pronterface, | ||
| - Connect to the printer using baud-rate 250000, and using the correct Serial/COM port for your printer. | - Connect to the printer using baud-rate 250000, and using the correct Serial/COM port for your printer. | ||
| - Pre-heat the bed to the printing temperature you normally use. | - Pre-heat the bed to the printing temperature you normally use. | ||
| - The bed will warp depending on temperature, | - The bed will warp depending on temperature, | ||
| + | |||
| + | === FAQ: What is GCode? === | ||
| + | Gcode is just the language for the instructions that the printer follows to perform a print. Cura or your slicer, simply translates the STL file into the GCode that the printer run on. Pronterface allows us a way to send individual GCode commands one by one, and this is the way we can communicate to the printer, and perform procedures like this one. | ||
| + | |||
| ==== How To Perform Mesh Bed Levelling ===== | ==== How To Perform Mesh Bed Levelling ===== | ||
a5/mesh-bed-levelling-routine.txt · Last modified: 2020/12/25 02:13 by 127.0.0.1
