a5:filament-sensor
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
a5:filament-sensor [2018/02/14 02:06] โ [Solution:] pinchies | a5:filament-sensor [2018/02/14 23:00] โ [Solution:] pinchies | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== A5/A3S filament Sensor ===== | + | ===== A5/A3S filament Sensor |
+ | ย | ||
+ | ==== Filament sensor pins ====ย | ||
+ | The pins for the filament sensor belong to the 6-pin header pins near the centre of the lcd module. The top two pins, in the right column of pins are used. There is a problem with the choice of connector JGAurora have used. | ||
====Problem: | ====Problem: | ||
Line 25: | Line 28: | ||
====Solution: | ====Solution: | ||
+ | **Edit: DaHai has since done a very clear [[https:// | ||
+ | |||
+ | |||
A simple solution is just to unplug the two wire cable sticking out of the LCD module! | A simple solution is just to unplug the two wire cable sticking out of the LCD module! | ||
However, if you want to use this feature, you can do this simple trick. Turning the connect 180 degrees, will make the metal side contacts face away from the other column of pins. Note that the JST connector they are using has three sockets, but only two are used. You need to make sure that the two wires are still connecting to the same two pins, but in this case we are effectively reversing the polarity. This is not a problem โ the sensor is a simple mechanical switch, so it does not matter which way electricity flows. | However, if you want to use this feature, you can do this simple trick. Turning the connect 180 degrees, will make the metal side contacts face away from the other column of pins. Note that the JST connector they are using has three sockets, but only two are used. You need to make sure that the two wires are still connecting to the same two pins, but in this case we are effectively reversing the polarity. This is not a problem โ the sensor is a simple mechanical switch, so it does not matter which way electricity flows. | ||
Line 37: | Line 43: | ||
{{ : | {{ : | ||
(Top Image Credit: Markus IngK - MCK, Bottom Image Credit: [[https:// | (Top Image Credit: Markus IngK - MCK, Bottom Image Credit: [[https:// | ||
- | |||
- | ==== Filament sensor pins ==== | ||
- | The pins for the filament sensor belong to the 6-pin header pins near the centre of the lcd module. The top two pins, in the right column of pins are used. |
a5/filament-sensor.txt ยท Last modified: 2020/12/25 02:13 by 127.0.0.1