a5:faq
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
a5:faq [2018/07/09 06:38] โ samuelpinches | a5:faq [2020/12/25 02:13] (current) โ external edit 127.0.0.1 | ||
---|---|---|---|
Line 33: | Line 33: | ||
* You must " | * You must " | ||
* You may also want to check you have [[stepper-drivers|tuned your stepper drivers]]. | * You may also want to check you have [[stepper-drivers|tuned your stepper drivers]]. | ||
+ | * Check for errors in [[/ | ||
---- | ---- | ||
Line 60: | Line 61: | ||
* Still not working? [[: | * Still not working? [[: | ||
* Faulty temperature readings? Check [[a5: | * Faulty temperature readings? Check [[a5: | ||
+ | * Bed not heating? [[a5: | ||
+ | * Bed still not heating? [[: | ||
---- | ---- | ||
Line 73: | Line 76: | ||
* [[a5: | * [[a5: | ||
* Check the [[https:// | * Check the [[https:// | ||
+ | |||
+ | ------------ | ||
+ | ====Problem: | ||
+ | |||
+ | * You may notice the printer restarts when starting a print, or perhaps when you preheat the bed | ||
+ | |||
+ | **Solutions: | ||
+ | |||
+ | This problem can be caused by TWO different causes: | ||
+ | |||
+ | * If your printer has a drag chain, please see [[A5: | ||
+ | * If your printer has clips on the bed, these clips may be scratching the bed heating element (underside of the bed) and causing a short circuit. Remove the clips, and place two layers of electrical tape on the underside of the bed. Then place the clips back on. | ||
+ | |||
------------ | ------------ | ||
Line 134: | Line 150: | ||
====Problem: | ====Problem: | ||
- | **Solution: | + | **Solution: |
----- | ----- |
a5/faq.1531082284.txt.gz ยท Last modified: 2020/12/25 02:13 (external edit)