Differences

This shows you the differences between two versions of the page.

--- a5:faq [2018/10/07 03:54] – [Problem: Heating Problems with Nozzle or Heated Bed] samuelpinches
+++ a5:faq [2019/02/25 13:02] – [Problem: The printer will not move, or will only move in one direction.] samuelpinches
@@ Line 33: / Line 33: @@
   * You must "Home" all the printer axis, before trying to move.
   * You may also want to check you have [[stepper-drivers|tuned your stepper drivers]].
+  * Check for errors in [[/pronterface|pronterface]].
 ----
@@ Line 148: / Line 149: @@
 ====Problem: My prints are very weak and very porous, there are lots of little holes in prints.====
-**Solution:** Check you have selected 1.75mm filament width in JGCreat/Cura.
+**Solution:** Check you have selected 1.75mm filament width in JGCreat/Cura, under the printer Machine Settings.
 -----

The Unofficial JGMaker (& JGAurora) Wiki