Differences

This shows you the differences between two versions of the page.

--- a5:faq [2018/09/24 20:45] – [Problem: Printer keeps rebooting when ever I try to heat the bed (or perhaps nozzle).] samuelpinches
+++ a5:faq [2020/04/13 16:19] – samuelpinches
@@ Line 33: / Line 33: @@
   * You must "Home" all the printer axis, before trying to move.
   * You may also want to check you have [[stepper-drivers|tuned your stepper drivers]].
+  * Check for errors in [[/pronterface|pronterface]].
 ----
@@ Line 60: / Line 61: @@
   * Still not working? [[:not-heating|Check this page for in-depth troubleshooting.]]
   * Faulty temperature readings? Check [[a5:faulty-temperature-readings|this page too]].
+  * Bed not heating? [[a5:drag-chain-cable-damage|Check if your bed cable is damaged inside the drag chain.]]
+  * Bed still not heating? [[:burned-bed-connectors|Check the Bed connector on the side of the bed is not damaged.]]
 ----
@@ Line 147: / Line 150: @@
 ====Problem: My prints are very weak and very porous, there are lots of little holes in prints.====
-**Solution:** Check you have selected 1.75mm filament width in JGCreat/Cura.
+**Solution:** Check you have selected 1.75mm filament width in JGCreat/Cura, under the printer Machine Settings.
 -----

The Unofficial JGMaker (& JGAurora) Wiki