a5:faq
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
a5:faq [2018/09/24 20:04] โ samuelpinches | a5:faq [2019/02/25 13:02] โ [Problem: The printer will not move, or will only move in one direction.] samuelpinches | ||
---|---|---|---|
Line 33: | Line 33: | ||
* You must " | * You must " | ||
* You may also want to check you have [[stepper-drivers|tuned your stepper drivers]]. | * You may also want to check you have [[stepper-drivers|tuned your stepper drivers]]. | ||
+ | * Check for errors in [[/ | ||
---- | ---- | ||
Line 60: | Line 61: | ||
* Still not working? [[: | * Still not working? [[: | ||
* Faulty temperature readings? Check [[a5: | * Faulty temperature readings? Check [[a5: | ||
+ | * Bed not heating? [[a5: | ||
---- | ---- | ||
Line 75: | Line 77: | ||
------------ | ------------ | ||
- | ====Problem: | + | ====Problem: |
* You may notice the printer restarts when starting a print, or perhaps when you preheat the bed | * You may notice the printer restarts when starting a print, or perhaps when you preheat the bed | ||
**Solutions: | **Solutions: | ||
- | * This is an ESPECIALLY common | + | ย |
- | * The cause is a short circuit, between the bed heating wires.ย | + | This problem |
- | * Please | + | ย |
+ | * If your printer has a drag chain, please | ||
+ | * If your printer has clips on the bed, these clips may be scratching the bed heating element (underside of the bed) and causing a short circuit. Remove the clips, and place two layers of electrical tape on the underside of the bed. Then place the clips back on. | ||
Line 145: | Line 149: | ||
====Problem: | ====Problem: | ||
- | **Solution: | + | **Solution: |
----- | ----- |
a5/faq.txt ยท Last modified: 2020/12/25 02:13 by 127.0.0.1