a5:drag-chain-cable-damage
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
a5:drag-chain-cable-damage [2018/09/24 20:13] โ samuelpinches | a5:drag-chain-cable-damage [2020/12/25 02:13] (current) โ external edit 127.0.0.1 | ||
---|---|---|---|
Line 13: | Line 13: | ||
- The insulation on the wires is silicone, which is very flexible. Because of this, they do not have enough weight or stiffness to function correctly in the drag chain. | - The insulation on the wires is silicone, which is very flexible. Because of this, they do not have enough weight or stiffness to function correctly in the drag chain. | ||
- | The result is, that the drag chain does not function correctly, and actually CAUSES the cables to fail in the same spot over time. Example photos are shown below: | + | The result is, that the drag chain does not function correctly, and actually CAUSES the cables to fail in the same spot over time. |
+ | **This is an ESPECIALLY common problem on ALL A5 printers fitted with drag chains. ** | ||
+ | **This defect can:** | ||
+ | * Cause sparks and zapping sounds inside the printer | ||
+ | * Cause the bed heating mosfet to be damaged | ||
+ | * Result in a short circuit that may cause the printer to reboot/ | ||
+ | |||
+ | ------------- | ||
+ | |||
+ | ==== Examples of this damage:==== | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | ------------- | ||
Line 24: | Line 45: | ||
==== SIMPLE OPTION ===== | ==== SIMPLE OPTION ===== | ||
- | One option, is to simply replace the cable, and remove the drag chain. This will work, but then you lose all the potential benefits that a drag cable chain offers. This is the option JGAurora chose to take on future A5 printers | + | One option, is to simply replace the cable, and remove the drag chain. This will work, but then you lose all the potential benefits that a drag cable chain offers. This is the option JGAurora chose to take on future A5 printers. |
====PROBABLY BETTER OPTION===== | ====PROBABLY BETTER OPTION===== | ||
Line 31: | Line 52: | ||
===== Spare Parts ===== | ===== Spare Parts ===== | ||
- | * [[: | + | You can [[: |
+ | ย | ||
+ | For higher quality cables, you should search for 16 gauge (or 16AWG) silicone wire.ย | ||
+ | Suppliers: | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[http:// |
a5/drag-chain-cable-damage.1537783998.txt.gz ยท Last modified: 2020/12/25 02:13 (external edit)