a5:bed-levelling
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| a5:bed-levelling [2018/06/15 12:33] – Added link to Bed Leveling Tutorial da-hai-zhu | a5:bed-levelling [2020/12/25 02:13] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 10: | Line 10: | ||
| === Non-warped beds === | === Non-warped beds === | ||
| - | | + | A video tutorial on Leveling the Bed can be found [[https:// |
| - Turn the bed heater on to printing temperature (~60 to 70C). | - Turn the bed heater on to printing temperature (~60 to 70C). | ||
| - Using the 4 thumb screws, use the levelling assistant on the front LCD to get the four corners of the printer bed perfectly level. Use a piece of paper (80GSM) to help you set the correct gap. Tighten the screw until the nozzle tip barely starts to grip or bite at the paper. Go over the 4 outer points several times until no further adjustment is required. | - Using the 4 thumb screws, use the levelling assistant on the front LCD to get the four corners of the printer bed perfectly level. Use a piece of paper (80GSM) to help you set the correct gap. Tighten the screw until the nozzle tip barely starts to grip or bite at the paper. Go over the 4 outer points several times until no further adjustment is required. | ||
| Line 25: | Line 25: | ||
| - Install the custom firmware on your printer, and go through the [[a5:mesh bed levelling routine]] to compensate for the uneven surface. | - Install the custom firmware on your printer, and go through the [[a5:mesh bed levelling routine]] to compensate for the uneven surface. | ||
| - Modify your printer with an [[a5: | - Modify your printer with an [[a5: | ||
| + | - Install the [[a5: | ||
a5/bed-levelling.1529030017.txt.gz · Last modified: 2020/12/25 02:13 (external edit)
