a5:bed-levelling
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
a5:bed-levelling [2018/02/20 11:33] โ pinchies | a5:bed-levelling [2020/12/25 02:13] (current) โ external edit 127.0.0.1 | ||
---|---|---|---|
Line 10: | Line 10: | ||
=== Non-warped beds === | === Non-warped beds === | ||
+ | A video tutorial on Leveling the Bed can be found [[https:// | ||
- Turn the bed heater on to printing temperature (~60 to 70C). | - Turn the bed heater on to printing temperature (~60 to 70C). | ||
- Using the 4 thumb screws, use the levelling assistant on the front LCD to get the four corners of the printer bed perfectly level. Use a piece of paper (80GSM) to help you set the correct gap. Tighten the screw until the nozzle tip barely starts to grip or bite at the paper. Go over the 4 outer points several times until no further adjustment is required. | - Using the 4 thumb screws, use the levelling assistant on the front LCD to get the four corners of the printer bed perfectly level. Use a piece of paper (80GSM) to help you set the correct gap. Tighten the screw until the nozzle tip barely starts to grip or bite at the paper. Go over the 4 outer points several times until no further adjustment is required. | ||
Line 24: | Line 25: | ||
- Install the custom firmware on your printer, and go through the [[a5:mesh bed levelling routine]] to compensate for the uneven surface. | - Install the custom firmware on your printer, and go through the [[a5:mesh bed levelling routine]] to compensate for the uneven surface. | ||
- Modify your printer with an [[a5: | - Modify your printer with an [[a5: | ||
+ | - Install the [[a5: |
a5/bed-levelling.1519086820.txt.gz ยท Last modified: 2020/12/25 02:13 (external edit)