a5:bed-levelling-probe
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| a5:bed-levelling-probe [2019/04/07 13:17] – [Initial Considerations] samuelpinches | a5:bed-levelling-probe [2019/04/07 13:22] – samuelpinches | ||
|---|---|---|---|
| Line 28: | Line 28: | ||
| The reason for this is if the motors turn enough to say, raise the bed 1mm, but for 50% of the movement, they stall because of the friction, your next probe measurement is going to be way off. I had probes that were (apparently) 44mm offset from probe point 1, that's utter madness and was caused by the motors stalling for a portion of their move on every single measurement point. **Lube up your rods people!** | The reason for this is if the motors turn enough to say, raise the bed 1mm, but for 50% of the movement, they stall because of the friction, your next probe measurement is going to be way off. I had probes that were (apparently) 44mm offset from probe point 1, that's utter madness and was caused by the motors stalling for a portion of their move on every single measurement point. **Lube up your rods people!** | ||
| + | |||
| + | See the [[: | ||
| Line 72: | Line 74: | ||
| Since this is what frightens most people, lets start here.\\ | Since this is what frightens most people, lets start here.\\ | ||
| * Grab a fresh copy of Marlin 1.1.8c from Sams repository http:// | * Grab a fresh copy of Marlin 1.1.8c from Sams repository http:// | ||
| - | * At the time of writing, you want the file "JG A5 Custom Main Marlin 1.1.8C.zip" | + | * At the time of writing, you want the file "JG A5 Custom Main Marlin 1.1.8C.zip" |
| * Extract the ZIP file and open up the Configuration.h file in Notepad or Arduino IDE 1.8.5 and make the following edits; \\ | * Extract the ZIP file and open up the Configuration.h file in Notepad or Arduino IDE 1.8.5 and make the following edits; \\ | ||
a5/bed-levelling-probe.txt · Last modified: 2020/12/25 02:13 by 127.0.0.1
