a5:bed-levelling-probe
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
a5:bed-levelling-probe [2019/04/07 03:07] โ More detail on pre-requites and troubleshooting steps. cs2000 | a5:bed-levelling-probe [2019/04/07 13:18] โ [Z Axis Friction] samuelpinches | ||
---|---|---|---|
Line 14: | Line 14: | ||
=====Initial Considerations===== | =====Initial Considerations===== | ||
- | From my testing and learning as a complete newbie to this whole automatic bed levelling jibberish, three things | + | From my testing and learning as a complete newbie to this whole automatic bed levelling jibberish, three things |
==== Levelling the X Axis ==== | ==== Levelling the X Axis ==== | ||
Line 28: | Line 28: | ||
The reason for this is if the motors turn enough to say, raise the bed 1mm, but for 50% of the movement, they stall because of the friction, your next probe measurement is going to be way off. I had probes that were (apparently) 44mm offset from probe point 1, that's utter madness and was caused by the motors stalling for a portion of their move on every single measurement point. **Lube up your rods people!** | The reason for this is if the motors turn enough to say, raise the bed 1mm, but for 50% of the movement, they stall because of the friction, your next probe measurement is going to be way off. I had probes that were (apparently) 44mm offset from probe point 1, that's utter madness and was caused by the motors stalling for a portion of their move on every single measurement point. **Lube up your rods people!** | ||
+ | |||
+ | See the [[: | ||
a5/bed-levelling-probe.txt ยท Last modified: 2020/12/25 02:13 by 127.0.0.1