a5:bed-levelling-probe
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| a5:bed-levelling-probe [2019/04/07 13:17] – [Initial Considerations] samuelpinches | a5:bed-levelling-probe [2019/04/07 13:18] – [Z Axis Friction] samuelpinches | ||
|---|---|---|---|
| Line 28: | Line 28: | ||
| The reason for this is if the motors turn enough to say, raise the bed 1mm, but for 50% of the movement, they stall because of the friction, your next probe measurement is going to be way off. I had probes that were (apparently) 44mm offset from probe point 1, that's utter madness and was caused by the motors stalling for a portion of their move on every single measurement point. **Lube up your rods people!** | The reason for this is if the motors turn enough to say, raise the bed 1mm, but for 50% of the movement, they stall because of the friction, your next probe measurement is going to be way off. I had probes that were (apparently) 44mm offset from probe point 1, that's utter madness and was caused by the motors stalling for a portion of their move on every single measurement point. **Lube up your rods people!** | ||
| + | |||
| + | See the [[: | ||
a5/bed-levelling-probe.txt · Last modified: 2020/12/25 02:13 by 127.0.0.1
