a5:bed-adhesion
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
a5:bed-adhesion [2018/08/29 02:39] โ [3. Print it SLOW] samuelpinches | a5:bed-adhesion [2020/12/25 02:13] (current) โ external edit 127.0.0.1 | ||
---|---|---|---|
Line 24: | Line 24: | ||
If the print is still not sticking, try loosening all four levelling thumb screws by 1/8th of a turn, and try again. This will reduce the first layer height very slightly. Repeat this until the print starts to stick well. | If the print is still not sticking, try loosening all four levelling thumb screws by 1/8th of a turn, and try again. This will reduce the first layer height very slightly. Repeat this until the print starts to stick well. | ||
+ | You may need to use [[a5: | ||
==== 6. Turn the fan speed down ==== | ==== 6. Turn the fan speed down ==== | ||
In most slicers there is the option to turn down the fan speed just for the first few layers that are printed. This may be good to try if your prints are curling in the first few layers. | In most slicers there is the option to turn down the fan speed just for the first few layers that are printed. This may be good to try if your prints are curling in the first few layers. |
a5/bed-adhesion.1535474378.txt.gz ยท Last modified: 2020/12/25 02:13 (external edit)