a5:bed-adhesion
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| a5:bed-adhesion [2018/08/25 12:36] – [3. Print it SLOW] samuelpinches | a5:bed-adhesion [2018/08/29 02:39] – [3. Print it SLOW] samuelpinches | ||
|---|---|---|---|
| Line 13: | Line 13: | ||
| Keep the speed for your first layer slow, to prevent parts being pulled off the bed. | Keep the speed for your first layer slow, to prevent parts being pulled off the bed. | ||
| - | 10-12mm/s is a good starting point for the first layer speed. | + | A first layer speed of 10-12mm/s is a good starting point. |
| ==== 4. Let it PREHEAT ==== | ==== 4. Let it PREHEAT ==== | ||
| - | The first time you print, you may want to set the print bed manually to the desired temperature (60-70C | + | The first time you print, you may want to set the print bed manually to the desired temperature (67C for pla), and wait 5 mins, in order to give the heat time to fully soak through the glass bed. |
| ==== 5. Adjust the initial layer height ==== | ==== 5. Adjust the initial layer height ==== | ||
a5/bed-adhesion.txt · Last modified: 2020/12/25 02:13 by 127.0.0.1
