a5:automatic-control-the-cold-end-fan
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
a5:automatic-control-the-cold-end-fan [2018/07/06 17:26] โ [Check The Proper Function] aeket | a5:automatic-control-the-cold-end-fan [2018/07/06 21:34] โ [Customize the Marlin firmware] samuelpinches | ||
---|---|---|---|
Line 93: | Line 93: | ||
For me, the default value of 150 works without problems. That's a good compromise between cooling performance and noise. \\ | For me, the default value of 150 works without problems. That's a good compromise between cooling performance and noise. \\ | ||
- | Then upload the changed firmware to the A5 (instructions here in the WIKI).\\ | + | Then upload the changed firmware to the A5 ([[a5: |
The 3D printer can now be reassembled. | The 3D printer can now be reassembled. | ||
\\ | \\ | ||
\\ | \\ | ||
- | |||
==== Check The Proper Function ==== | ==== Check The Proper Function ==== | ||
a5/automatic-control-the-cold-end-fan.txt ยท Last modified: 2020/12/25 02:13 by 127.0.0.1