z-603s
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
z-603s [2018/04/21 22:01] โ samuelpinches | z-603s [2020/12/25 02:13] (current) โ external edit 127.0.0.1 | ||
---|---|---|---|
Line 4: | Line 4: | ||
* [[https:// | * [[https:// | ||
+ | * [[https:// | ||
* [[https:// | * [[https:// | ||
* [[https:// | * [[https:// | ||
Line 11: | Line 12: | ||
{{section>: | {{section>: | ||
- | |||
{{section>: | {{section>: | ||
Line 41: | Line 41: | ||
* Warped beds are common in the early models at least. | * Warped beds are common in the early models at least. | ||
* Poor cable management, no drag chains. | * Poor cable management, no drag chains. | ||
- | * Poor strain relief at print head, prone to fatigue failure at print head over time.ย | + | * Poor strain relief at print head, prone to fatigue failure at print head over long term use.ย |
- | * Frustrating print head design makes it very tedious to clean extruder gear, or to insert new filament (unguided filament path).ย | + | * Frustrating print head design makes it tedious to clean extruder gear, or to insert new filament (unguided filament path).ย |
- | * Not easy to service. | + | * Not easy to service. |
- | * Poor blower fan duct | + | |
==== Versions ==== | ==== Versions ==== | ||
Line 60: | Line 59: | ||
[[https:// | [[https:// | ||
- | ==== Custom | + | ===== Firmware |
* **[[z-603s: | * **[[z-603s: | ||
* Smoother printer movement for better surface printing quality | * Smoother printer movement for better surface printing quality | ||
Line 68: | Line 67: | ||
* Full source code to enable mods and enhancements | * Full source code to enable mods and enhancements | ||
- | ==== Modifications & Upgrades ==== | + | ===== Modifications & Upgrades |
* [[z-603s: | * [[z-603s: | ||
* [[z-603s: | * [[z-603s: | ||
Line 74: | Line 73: | ||
* [[z-603s: | * [[z-603s: | ||
* [[z-603s: | * [[z-603s: | ||
+ | * [[https:// | ||
+ | |||
+ | **DIY Enclosure (by [[https:// | ||
+ | |||
+ | == 3D Printer Parts == | ||
+ | |||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | |||
+ | == Laser Cut Parts == | ||
+ | *Coming Soon | ||
===== Troubleshooting ===== | ===== Troubleshooting ===== | ||
Line 81: | Line 92: | ||
==== General Troubleshooting ==== | ==== General Troubleshooting ==== | ||
- | * [[general-troubleshooting|Is your printer behaving erratically? | ||
* [[not-heating|Is your printer not heating up?]] | * [[not-heating|Is your printer not heating up?]] | ||
+ | * Download the free software **[[http:// | ||
==== Maintenance ==== | ==== Maintenance ==== | ||
* [[z-603s: | * [[z-603s: |
z-603s.1524312080.txt.gz ยท Last modified: 2020/12/25 02:13 (external edit)