start-and-end-gcode
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
start-and-end-gcode [2019/11/16 13:02] โ samuelpinches | start-and-end-gcode [2020/04/28 23:48] โ [Starting GCode] samuelpinches | ||
---|---|---|---|
Line 17: | Line 17: | ||
===Default Start Script=== | ===Default Start Script=== | ||
* G28 ; Home all axis | * G28 ; Home all axis | ||
- | * G1 Z15.0 F6000 ; Move up 15mm at 6000mm/min (note: more than the max speed set in the printer firmware) | + | * G1 Z15.0 F1000 ; Move up 15mm at 1000mm/min |
* G92 E0 ; Reset extruder length to zero | * G92 E0 ; Reset extruder length to zero | ||
* G1 F200 E10 ; Extrude 10mm at 200mm/min | * G1 F200 E10 ; Extrude 10mm at 200mm/min | ||
Line 31: | Line 31: | ||
* G28 ; Home all axis | * G28 ; Home all axis | ||
- | * G1 Z15.0 F6000 ; Move up 15mm at 6000mm/min (note: more than the max speed set in the printer firmware) | + | * G1 Z15.0 F1000 ; Move up 15mm at 1000mm/min |
* G92 E0 ; Reset extruder length to zero | * G92 E0 ; Reset extruder length to zero | ||
* G1 X0.0 Y0.0 F1000.0 ; go to edge of print area | * G1 X0.0 Y0.0 F1000.0 ; go to edge of print area |
start-and-end-gcode.txt ยท Last modified: 2020/12/25 02:13 by 127.0.0.1