start-and-end-gcode
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
start-and-end-gcode [2019/11/16 13:00] โ [Ending GCode] samuelpinches | start-and-end-gcode [2019/11/16 13:02] โ samuelpinches | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | e4444======Starting & Ending GCode ====== | + | ======Starting & Ending GCode ====== |
In your slicer you will have a section for GCode commands that are run at the very start and end of every print. In Cura/ | In your slicer you will have a section for GCode commands that are run at the very start and end of every print. In Cura/ |
start-and-end-gcode.txt ยท Last modified: 2020/12/25 02:13 by 127.0.0.1