start-and-end-gcode

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
start-and-end-gcode [2019/11/16 02:00]
samuelpinches [Ending GCode]
start-and-end-gcode [2019/11/16 02:02] (current)
samuelpinches
Line 1: Line 1:
-e4444======Starting & Ending GCode ======+======Starting & Ending GCode ======
  
 In your slicer you will have a section for GCode commands that are run at the very start and end of every print. In Cura/​JGCreat,​ these are found in the machine settings. In your slicer you will have a section for GCode commands that are run at the very start and end of every print. In Cura/​JGCreat,​ these are found in the machine settings.
start-and-end-gcode.txt ยท Last modified: 2019/11/16 02:02 by samuelpinches