Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision |
pronterface [2018/04/28 19:47] โ samuelpinches | pronterface [2020/12/25 02:13] (current) โ external edit 127.0.0.1 |
---|
| |
After installing Pronterface, connect to the printer using Baud 250000, and choose the correct serial port for your printer. | After installing Pronterface, connect to the printer using Baud 250000, and choose the correct serial port for your printer. |
| |
| Then, you can print your file from Pronterface, while monitoring for any error messages. |
| |
---- | ---- |
---- | ---- |
| |
Common Errors & Faults | === Common Errors & Faults === |
| |
If you see an error about "MIN_TEMP" the printer has detected a temperature that is too low, and it thinks that a sensor is either damaged or missing. For safety, the printer will then refuse to heat up, to prevent burning your house down! There is a broken wire, or loose connection somewhere. Perhaps a leg of the thermistor has broken off, or a cable is detached or loose? | If you see an error about "MIN_TEMP" the printer has detected a temperature that is too low, and it thinks that a sensor is either damaged or missing. For safety, the printer will then refuse to heat up, to prevent burning your house down! There is a broken wire, or loose connection somewhere. Perhaps a leg of the thermistor has broken off, or a cable is detached or loose? |