a5:printing-profiles
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
a5:printing-profiles [2018/05/04 23:01] โ samuelpinches | a5:printing-profiles [2019/04/30 08:00] โ S3D Profiles cs2000 | ||
---|---|---|---|
Line 12: | Line 12: | ||
==== Copying settings from JGCreat to Cura ==== | ==== Copying settings from JGCreat to Cura ==== | ||
- | Want to use the latest Ultimaker | + | If you want to use Cura, but keep the JGCreat |
- Make sure both [[: | - Make sure both [[: | ||
- In File Explorer, navigate to C:\Program Files\JGcreat 2.5.0\resources\definitions | - In File Explorer, navigate to C:\Program Files\JGcreat 2.5.0\resources\definitions | ||
Line 23: | Line 23: | ||
Thanks to Steve Wagg for this tip! | Thanks to Steve Wagg for this tip! | ||
- | {{: | + | {{ : |
====Starting & Ending GCode ==== | ====Starting & Ending GCode ==== | ||
Line 55: | Line 55: | ||
You can setup IdeaMaker with the A5 printer, by using these machine settings [[https:// | You can setup IdeaMaker with the A5 printer, by using these machine settings [[https:// | ||
Source: Charles Eakins @ https:// | Source: Charles Eakins @ https:// | ||
+ | |||
+ | ==== Simplify3D==== | ||
+ | Simplify3D is perhaps one of the best paid slicers out there, i would recommend setting your machine up yourself to learn the software, but if you want to just get printing, grab my FFF profiles from the link below. [[https:// | ||
+ | Source: Cs2000 |
a5/printing-profiles.txt ยท Last modified: 2020/12/25 02:13 by 127.0.0.1