a5:printing-profiles
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
a5:printing-profiles [2018/03/02 23:01] โ samuelpinches | a5:printing-profiles [2019/04/30 08:00] โ S3D Profiles cs2000 | ||
---|---|---|---|
Line 2: | Line 2: | ||
==== Slicer Setup ==== | ==== Slicer Setup ==== | ||
- | A slicer is what takes your 3D file (STL, OBJ), and turns it into a series of movement commands (G-Code) that the printer' | + | A slicer is what takes your 3D file (STL, OBJ), and turns it into a series of movement commands (G-Code) that the printer' |
- | **We recommend you download the [[https:// | + | **We recommend you download the [[https:// |
- | You can setup a current version of Cura by selecting the " | + | You can setup a current version of Cura by selecting the " |
+ | {{ : | ||
+ | Source: [[https:// | ||
+ | |||
+ | ==== Copying settings from JGCreat to Cura ==== | ||
+ | If you want to use Cura, but keep the JGCreat printing profiles, then follow the following steps to copy across the profiles: | ||
+ | - Make sure both [[: | ||
+ | - In File Explorer, navigate to C:\Program Files\JGcreat 2.5.0\resources\definitions | ||
+ | - Copy all the files in there. These files all end in " | ||
+ | - In File Explorer navigate to C:\Program Files\Ultimaker Cura 3.1\resources\definitions | ||
+ | - Paste the copied files. | ||
+ | - Start Cura up and click settings --> printer --> add printer | ||
+ | - Choose your JGAurora printer from the menu (should look like image below - click to enlarge). | ||
+ | - Easy : | ||
+ | Thanks to Steve Wagg for this tip! | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | ====Starting & Ending GCode ==== | ||
+ | You will notice two text boxes in the machine settings. These contain GCode commands that are run at the very start and end of the print. See this article on [[: | ||
==== Printing Profiles ==== | ==== Printing Profiles ==== | ||
Line 36: | Line 55: | ||
You can setup IdeaMaker with the A5 printer, by using these machine settings [[https:// | You can setup IdeaMaker with the A5 printer, by using these machine settings [[https:// | ||
Source: Charles Eakins @ https:// | Source: Charles Eakins @ https:// | ||
+ | |||
+ | ==== Simplify3D==== | ||
+ | Simplify3D is perhaps one of the best paid slicers out there, i would recommend setting your machine up yourself to learn the software, but if you want to just get printing, grab my FFF profiles from the link below. [[https:// | ||
+ | Source: Cs2000 |
a5/printing-profiles.txt ยท Last modified: 2020/12/25 02:13 by 127.0.0.1