a5:filament-sensor
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| a5:filament-sensor [2018/02/14 23:06] – [TL;DR] pinchies | a5:filament-sensor [2020/12/25 02:13] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 8: | Line 8: | ||
| The pins for the filament sensor belong to the 6-pin header pins near the centre of the lcd module. The top two pins, in the right column of pins are used. There is a problem with the choice of connector JGAurora have used. | The pins for the filament sensor belong to the 6-pin header pins near the centre of the lcd module. The top two pins, in the right column of pins are used. There is a problem with the choice of connector JGAurora have used. | ||
| + | Note: This issue has been resolved by JGAurora in recently manufactured machines by using hot glue to both insulate the other pins, and to hold the connector in place correctly. | ||
| ====Problem: | ====Problem: | ||
| When you try to print, the print may stop (or may fail to start at all), and instead the printer will make a loud beeping sound. | When you try to print, the print may stop (or may fail to start at all), and instead the printer will make a loud beeping sound. | ||
a5/filament-sensor.1518609995.txt.gz · Last modified: 2020/12/25 02:13 (external edit)
