a5:filament-sensor
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
| a5:filament-sensor [2018/03/08 07:22] – [Filament sensor pins] samuelpinches | a5:filament-sensor [2018/03/08 07:22] – [Filament sensor pins] samuelpinches | ||
|---|---|---|---|
| Line 8: | Line 8: | ||
| The pins for the filament sensor belong to the 6-pin header pins near the centre of the lcd module. The top two pins, in the right column of pins are used. There is a problem with the choice of connector JGAurora have used. | The pins for the filament sensor belong to the 6-pin header pins near the centre of the lcd module. The top two pins, in the right column of pins are used. There is a problem with the choice of connector JGAurora have used. | ||
| - | This issue has been resolved by JGAurora by using hot glue to both insulate the other pins, and to hold the connector in place correctly. | + | Note: This issue has been resolved by JGAurora |
| ====Problem: | ====Problem: | ||
| When you try to print, the print may stop (or may fail to start at all), and instead the printer will make a loud beeping sound. | When you try to print, the print may stop (or may fail to start at all), and instead the printer will make a loud beeping sound. | ||
a5/filament-sensor.txt · Last modified: 2020/12/25 02:13 by 127.0.0.1
