a5:faq
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
a5:faq [2018/07/09 06:37] โ samuelpinches | a5:faq [2020/12/25 02:13] (current) โ external edit 127.0.0.1 | ||
---|---|---|---|
Line 33: | Line 33: | ||
* You must " | * You must " | ||
* You may also want to check you have [[stepper-drivers|tuned your stepper drivers]]. | * You may also want to check you have [[stepper-drivers|tuned your stepper drivers]]. | ||
+ | * Check for errors in [[/ | ||
---- | ---- | ||
Line 60: | Line 61: | ||
* Still not working? [[: | * Still not working? [[: | ||
* Faulty temperature readings? Check [[a5: | * Faulty temperature readings? Check [[a5: | ||
+ | * Bed not heating? [[a5: | ||
+ | * Bed still not heating? [[: | ||
---- | ---- | ||
Line 75: | Line 78: | ||
------------ | ------------ | ||
- | {{ :a5:a5-adjust-z-endstop.jpg? | + | ====Problem: Printer keeps rebooting when ever I try to heat the bed (or perhaps start a print).====ย |
+ | ย | ||
+ | * You may notice the printer restarts when starting a print, or perhaps when you preheat the bedย | ||
+ | ย | ||
+ | **Solutions:**ย | ||
+ | ย | ||
+ | This problem can be caused by TWO different causes:ย | ||
+ | ย | ||
+ | * If your printer has a drag chain, please see [[A5:drag-chain-cable-damage|this article for details]].ย | ||
+ | * If your printer has clips on the bed, these clips may be scratching the bed heating element (underside of the bed) and causing a short circuit. Remove the clips, and place two layers of electrical tape on the underside of the bed. Then place the clips back on. ย | ||
+ | ย | ||
+ | ย | ||
+ | ------------ | ||
====Problem: | ====Problem: | ||
+ | | ||
+ | {{ : | ||
+ | |||
* When you try to home the z axis, the nozzle is still too far away from the bed. | * When you try to home the z axis, the nozzle is still too far away from the bed. | ||
* You may find that you cannot loosen the bed screws far enough | * You may find that you cannot loosen the bed screws far enough | ||
Line 132: | Line 150: | ||
====Problem: | ====Problem: | ||
- | **Solution: | + | **Solution: |
----- | ----- |
a5/faq.1531082227.txt.gz ยท Last modified: 2020/12/25 02:13 (external edit)